Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA

RADIO ANTENNA > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FENDER ANTENNA ASSEMBLY


B164821
  1. Install the antenna with the bolt.



    B164822
  1. Attach the 5 clamps and install the bolt.

  1. Connect the connector.



2. INSTALL FENDER APRON MUDGUARD SEAL RH


  1. for Steel Type Bumper:
    Install the fender apron mudguard seal.



    1. Install the fender apron mudguard with the 3 clips and 15 new clips labeled A.


      B165874E01

    2. w/ Front Fender Mudguard:
      Install the front fender mudguard .

    3. w/ Side Step:
      Install the side step .



  1. for Resin Type Bumper:
    Install the fender apron mudguard seal.

    1. Install the fender apron mudguard with the 2 clips and 15 new clips labeled A.



    2. Install the pin hold clip so that its groove is vertical.


      B166532E01

    3. w/ Front Fender Mudguard:
      Install the front fender mudguard .

    4. w/ Side Step:
      Install the side step .



3. INSTALL ANTENNA ORNAMENT


B164820
  1. Install the antenna ornament as shown in the illustration.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL