Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA

RADIO ANTENNA > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE ANTENNA ORNAMENT


B164819
  1. Remove the antenna ornament as shown in the illustration.



4. REMOVE FENDER APRON MUDGUARD SEAL RH


  1. for Steel Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .



    3. Remove the 18 clips and fender apron mudguard.


      B165874E02



  1. for Resin Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .

    3. Using a screwdriver, remove the pin hold clip.



    4. Remove the 17 clips and fender apron mudguard.


      B165876E01



5. REMOVE FENDER ANTENNA ASSEMBLY


B164822
  1. Disconnect the connector.

  1. Remove the bolt and detach the 5 clamps.



    B164821
  1. Remove the bolt and antenna.