Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA POLE

RADIO ANTENNA POLE > INSTALLATION

for Preparation Click here



1. INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY


    E230841
  1. Install the pull top antenna pole sub-assembly and tighten it by hand until it is fully seated.

  1. Using an 8 mm (0.315 in) wrench, or antenna mast tool, tighten the antenna pole clockwise approximately 1/8 turn (20 to 45 degrees).

    HINT:
    1. Do not overtighten the antenna pole. Tighten the antenna pole with your fingers, not your whole hand.
    2. Do not use pliers to tighten the antenna pole as it can leave marks on the antenna pole surface.
    3. The antenna pole cannot tightened by hand to the proper torque specification.

    Torque:
    3.3 N*m{ 3.4 kgf*cm , 29 in.*lbf }