RADIO RECEIVER (for Column Shift Type) > INSTALLATION |
| 1. INSTALL NO. 2 RADIO BRACKET (w/ USB Audio System) |
![]() |
Install the bracket with the 3 bolts.
| 2. INSTALL NO. 1 RADIO BRACKET (w/ USB Audio System) |
![]() |
Install the bracket with the 3 bolts.
| 3. INSTALL RADIO RECEIVER ASSEMBLY (w/ USB Audio System) |
![]() |
Connect the connectors.
Insert the radio receiver and attach the 3 clips on its backside.
![]() |
Install the radio receiver with the 4 bolts.
| 4. INSTALL NO. 2 RADIO BRACKET (w/o USB Audio System) |
![]() |
Install the bracket with the 3 bolts.
| 5. INSTALL NO. 1 RADIO BRACKET (w/o USB Audio System) |
![]() |
Install the bracket with the 3 bolts.
| 6. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o USB Audio System) |
![]() |
Connect the connectors.
Insert the radio receiver and attach the 3 clips on its backside.
![]() |
Install the radio receiver with the 4 bolts.
| 7. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Connect the connectors.
Attach the 4 clips to install the panel.
| 8. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Connect the connectors.
Attach the 4 clips to install the panel.
| 9. INSTALL INSTRUMENT PANEL CUP HOLDER ASSEMBLY |
![]() |
Attach the 4 clips to install the cup holder.
Install the 4 screws.
![]() |
Attach the 2 claws to install the door box.
| 10. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL |
![]() |
Connect the connectors.
Attach the 4 clips to install the finish panel.
Install the 2 screws.
| 11. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY |
| 12. INSTALL CENTER LOWER INSTRUMENT COVER |
Install the cover with the 2 clips.

| 13. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Connect the connector and attach the wire harness clamp.
Attach the 12 clips to install the finish panel.
| 14. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
for Automatic Air Conditioning System:
Attach the 2 claws to install the sensor.
![]() |
Connect the connectors.
Attach the 9 clips and claw to install the finish panel.
Install the 2 bolts.
Install the hood lock control lever.
| 15. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 7 claws to install the side panel.
| 16. INSTALL COWL SIDE TRIM BOARD LH |
![]() |
Attach the 2 clips to install the cowl side trim board.
Install the clip.
| 17. INSTALL FRONT DOOR SCUFF PLATE LH |
for Double Cab:
Install the front door scuff plate LH .
for Regular Cab:
Install the front door scuff plate LH .
for CrewMax:
Install the front door scuff plate LH .
| 18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |