Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION RECEIVER (for Column Shift Type)

NAVIGATION RECEIVER (for Column Shift Type) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 RADIO BRACKET


    E232004
  1. Install the bracket with the 4 bolts.

    Torque:
    4.5 N*m{ 45 kgf*cm , 39 in.*lbf }



2. INSTALL NO. 1 RADIO BRACKET


    E232003
  1. Install the bracket with the 4 bolts.

    Torque:
    4.5 N*m{ 45 kgf*cm , 39 in.*lbf }



3. INSTALL UPPER INSTRUMENT CLUSTER FINISH PANEL


    B229213
  1. Install the upper instrument cluster finish panel with the 4 screws.



4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


E232005
  1. Connect the connectors.

  1. Insert the navigation receiver as shown in the illustration to attach the 2 clips on its backside.

    NOTICE:
    When inserting the navigation receiver, do not press the knobs on it.



    E232001
  1. Install the navigation receiver with the 4 bolts.

    Torque:
    8.0 N*m{ 81 kgf*cm , 70 in.*lbf }



5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (for Manual Air Conditioning System)


B160589
  1. Connect the connectors.

  1. Attach the 4 clips to install the panel.



6. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Air Conditioning System)


B160588
  1. Connect the connectors.

  1. Attach the 4 clips to install the panel.



7. INSTALL INSTRUMENT PANEL CUP HOLDER ASSEMBLY


    B161767
  1. Attach the 4 clips to install the cup holder.

  1. Install the 4 screws.



    B163941
  1. Attach the 2 claws to install the door box.



8. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL


    B160587
  1. Connect the connectors.

  1. Attach the 4 clips to install the finish panel.

  1. Install the 2 screws.



9. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY


10. INSTALL CENTER LOWER INSTRUMENT COVER


  1. Install the cover with the 2 clips.


    B171284E01



11. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B227982
  1. Connect the connector and attach the wire harness clamp.

  1. Attach the 12 clips to install the finish panel.



12. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B163883
  1. for Automatic Air Conditioning System:
    Attach the 2 claws to install the sensor.



    B226740
  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 bolts.

  1. Install the hood lock control lever.



13. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



14. INSTALL COWL SIDE TRIM BOARD LH


B165704
  1. Attach the 2 clips to install the cowl side trim board.

  1. Install the clip.



15. INSTALL FRONT DOOR SCUFF PLATE LH
  1. for Double Cab:
    Install the front door scuff plate LH .

  1. for CrewMax:
    Install the front door scuff plate LH .

  1. for Regular Cab:
    Install the front door scuff plate LH .



16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL