Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION RECEIVER (for Column Shift Type)

NAVIGATION RECEIVER (for Column Shift Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT DOOR SCUFF PLATE LH
  1. for Double Cab:
    Remove the front door scuff plate LH .

  1. for CrewMax:
    Remove the front door scuff plate LH .

  1. for Regular Cab:
    Remove the front door scuff plate LH .



4. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B226740
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



7. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B227982
  1. Disconnect the connector and detach the wire harness clamp.

  1. Detach the 12 clips and remove the finish panel.



8. REMOVE CENTER LOWER INSTRUMENT COVER


  1. Remove the 2 clips and cover.


    B171284E01



9. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY


10. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL


    B160587
  1. Remove the 2 screws.

  1. Detach the 4 clips.

  1. Remove the finish panel and then disconnect the connectors.



11. REMOVE INSTRUMENT PANEL CUP HOLDER ASSEMBLY


    B161766
  1. Detach the 2 claws and remove the door box.



    B161767
  1. Remove the 4 screws.

  1. Detach the 4 clips and remove the cup holder.



12. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Manual Air Conditioning System)


    B160589
  1. Detach the 4 clips.

  1. Remove the panel and then disconnect the connectors.



13. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Air Conditioning System)


    B160588
  1. Detach the 4 clips.

  1. Remove the panel and then disconnect the connectors.



14. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


    E232001
  1. Remove the 4 bolts.



    E232002
  1. Pull the navigation receiver as shown in the illustration to detach the 2 clips on the backside of the navigation receiver.

  1. Disconnect the connectors and remove the navigation receiver.



15. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL


    B229213
  1. Remove the 4 screws and upper instrument cluster finish panel.



16. REMOVE NO. 1 RADIO BRACKET


    E232003
  1. Remove the 4 bolts and bracket.



17. REMOVE NO. 2 RADIO BRACKET


    E232004
  1. Remove the 4 bolts and bracket.