Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for CrewMax)

FRONT DOOR SPEAKER (for CrewMax) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E02
  1. Detach the 3 clips and remove the front lower door frame bracket garnish.



4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT UPPER ARMREST BASE PANEL LH


    B166211
  1. Using a screwdriver, detach the 2 clips and front upper armrest base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



6. REMOVE FRONT DOOR ARMREST COVER LH


7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B166215E01
  1. Remove the 2 screws.

  1. Remove the clip.

  1. Detach the 9 clips and remove the trim board cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY



B165744E03

  1. Disconnect the speaker connector.

  1. Remove the 4 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



9. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)


B171783
  1. Remove the 3 screws and speaker with bracket.



    B165754E01
  1. Detach the 3 claws and remove the speaker from the bracket.

    NOTICE:
    Do not touch the cone part of the speaker.