Home › BODY ELECTRICAL › AUDIO / VISUAL › INSTRUMENT PANEL SPEAKER (for CrewMax)

INSTRUMENT PANEL SPEAKER (for CrewMax) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT PILLAR GARNISH LH
  1. Using a screwdriver, detach the 2 claws and remove the 2 assist grip plugs.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 bolts and assist grip.



  1. Detach the claw and remove the front pillar garnish.


    B165705E08



    B165709E06
  1. Protect the curtain shield airbag.

    1. Thoroughly cover the airbag with a cloth or nylon sheet and fix the ends of the cover with adhesive tape, as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.



4. REMOVE FRONT PILLAR GARNISH RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


B165747
  1. Using a screwdriver, detach the 4 clips and claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the speaker panel.



6. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


B166271
  1. Using a screwdriver, detach the 4 clips and claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the speaker panel.



7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY LH



B165750E02

  1. Remove the 2 bolts.

  1. Remove the speaker and disconnect the connector.

    NOTICE:
    Do not touch the cone part of the speaker.



8. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY RH



B166276E02

  1. Remove the 2 bolts.

  1. Remove the speaker and disconnect the connector.

    NOTICE:
    Do not touch the cone part of the speaker.



9. REMOVE NO. 3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


B165748
  1. Using a screwdriver, detach the 6 clips and 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the speaker panel.



10. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY (for 12 Speakers)


B165751E01
  1. Remove the 2 bolts.

  1. Remove the speaker and disconnect the connector.

    NOTICE:
    Do not touch the cone part of the speaker.