NAVIGATION SYSTEM (for SD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the K23 navigation receiver assembly connector.
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K23-17 (ALI) - J100-6 | Always | Below 1 Ω |
| K23-15 (ARI) - J100-5 | Always | Below 1 Ω |
| K23-16 (ASGN) - J100-7 | Always | Below 1 Ω |
| K23-18 (AGND) - J100-9 | Always | Below 1 Ω |
| K23-19 (AUXI) - J100-8 | Always | Below 1 Ω |
| K23-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| K23-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| K23-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| K23-18 (AGND) - Body ground | Always | 10 kΩ or higher |
| K23-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||