Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY


    E146306
  1. Install the wiper motor with the 3 bolts.

    Torque:
    7.5 N*m{ 75 kgf*cm , 66 in.*lbf }



    E146318E01
  1. Apply MP grease to the crank arm pivot of the wiper motor.

  1. Install the rod of the wiper link to the crank arm, as shown in the illustration.



2. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY


    E146300
  1. Install the wiper motor and link assembly with the 4 bolts and nut.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the connector.



3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E146307
  1. Push the ventilator louver in the direction indicated by the arrow in the illustration to attach 8 claws and 2 clips, and install the ventilator louver.



4. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
  1. Attach the claw to install the cowl side seal.



5. INSTALL FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL HOOD TO COWL TOP SEAL


    E146298
  1. Attach the 16 claws and install the cowl top seal.



7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E146308E01
  1. Stop the wiper motor at the automatic stop position.

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    E146317E01
  1. Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade comes to the position shown in the illustration.

    Standard measurement:
    Position
    Specified Condition
    A
    23.9 mm (0.941 in.)
    B
    35.5 mm (1.40 in.)

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold down the wiper arm hinge with your hand while tightening the nut.



8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E146308E01
  1. Stop the wiper motor at the automatic stop position.

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    E146310E01
  1. Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade comes to the position shown in the illustration.

    Standard measurement:
    Position
    Specified Condition
    A
    11.5 mm (0.453 in.)
    B
    29.8 mm (1.17 in.)

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold down the wiper arm hinge with your hand while tightening the nut.

  1. Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and there is no interference with the vehicle body.