Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for Regular Cab)

FRONT DOOR BELT MOULDING (for Regular Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH


B165858
  1. Attach the claw to install the weatherstrip.



2. INSTALL FRONT REAR DOOR GUIDE BRACKET GARNISH LH
  1. Clean the radiator front door surface.

    1. Using a heat light, heat the front door surface.

    2. Remove the double-sided tape from the front door.

    3. Wipe off any tape adhesive residue with cleaner.



  1. If reusing the garnish:
    Clean the garnish.

    1. Remove the double-sided tape from the garnish.

    2. Wipe off any tape adhesive residue with cleaner.



    3. B166190E06
    4. Apply new double-sided tape to the garnish, as shown in the illustration.



  1. Install the garnish.

    1. Remove the peeling paper from the face of the garnish.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.



    2. B166189E05
    3. Attach the 2 claws in the order shown in the illustration to install the garnish.

      HINT:
      Press the garnish firmly to install it.



3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


B166364E01
  1. Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.

  1. Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. w/ Power Mirror Control System:
    Connect the connector labeled A.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.

  1. Attach the 10 clips to install the door trim board.



    B167314E01
  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Attach the clip.



5. INSTALL FRONT DOOR ARMREST COVER LH


6. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Attach the 3 clips to install the front lower door frame bracket garnish.



7. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B165697E01
  1. Install the plate and regulator handle with the snap ring.

    HINT:
    With the door window fully closed, install the plate and the regulator handle with the snap ring as shown in the illustration.



8. INSTALL FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B165649E01
  1. Connect the connectors.

  1. Attach the 2 clips to install the front upper armrest base panel.



9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E01
  1. Attach the 4 claws to install the bezel plug.