WIPER AND WASHER SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Warm up the engine.
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Body / Combination Meter / Data List.
According to the display on the Techstream, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Washer Switch | Washer fluid level warning switch / ON or OFF | ON: Washer jar is empty OFF: Washer jar is full | - |