Home › BODY › SEAT › SEAT HEATER CONTROL (w/ Seat Heater System or Climate Control Seat System)

SEAT HEATER CONTROL (w/ Seat Heater System or Climate Control Seat System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH


B166556E03
  1. Disconnect the Z11 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    Z11-6 (E) - Body ground
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Z11-1 (SWL) - Z11-6 (E)
    Ignition switch ON, seat heater switch OFF
    Below 1 V
    Ignition switch ON, seat heater switch ON
    11 to 14 V
    Z11-4 (B) - Z11-6 (E)
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Connect the Z11 connector.



    B167840E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Z11-5 (THL) - Body ground
    Ignition switch ON, seat heater switch ON, volume MIN → MAX
    Gradual increase between below 1 V and 11 to 14 V

    If the result is not as specified, the seat heater control may have a malfunction.



2. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH


B166556E02
  1. Disconnect the Y8 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    Y8-6 (E) - Body ground
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Y8-1 (SWL) - Y8-6 (E)
    Ignition switch ON, seat heater switch OFF
    Below 1 V
    Ignition switch ON, seat heater switch ON
    11 to 14 V
    Y8-4 (B1) - Y8-6 (E)
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Connect the Y8 connector.



    B167840E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Y8-5 (THL) - Body ground
    Ignition switch ON, seat heater switch ON, volume MIN → MAX
    Gradual increase between below 1 V and 11 to 14 V

    If the result is not as specified, the seat heater control may have a malfunction.