Home › BODY › SEAT › FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat)

FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat) > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat)


    B165519
  1. Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.

    HINT:
    Tape the screwdriver tip before use.



    B165520
  1. Remove the 2 screws and vertical adjuster handle.



3. REMOVE VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat)


    B165522
  1. Remove the snap ring and vertical seat adjuster knob.



4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


B165521
  1. Lift the reclining adjuster release handle.

  1. Using a screwdriver, detach the claw and remove the reclining adjuster release handle.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT SEAT CUSHION SHIELD LH


    B165523E01
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.



    B165524E01
  1. Remove the 2 screws.

  1. Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.

  1. w/ Lumbar Support Adjuster:
    Disconnect the switch connector.



6. REMOVE FRONT POWER SEAT LUMBAR SWITCH LH


B194037
  1. Remove the 2 screws and switch.