Home › DRIVE LINE › JF1A TRANSFER › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



2. REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab, for CrewMax)
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH
  1. Remove the cowl side trim board RH .

    HINT:
    Use the same procedures described for the LH side.



4. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B226741
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



6. REMOVE 4WD CONTROL ECU


    C160016
  1. Disconnect the 2 ECU connectors.

  1. Remove the bolt and ECU.