Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PRESSURE SWITCH

PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. REMOVE PRESSURE SWITCH


E146755
  1. Disconnect the connector.

  1. Remove the switch.

  1. Remove the O-ring from the pressure switch.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.