Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT ROOM LIGHT SWITCH ASSEMBLY


    E146766E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (FCTY) - 10 (FLMP)
    Room light switch DOOR
    Below 1 Ω
    10 (FLMP) - 7 (E)
    Room light switch ON

    If the result is not as specified, replace the switch.

  1. Inspect the switch illumination.

    1. Connect the battery's positive (+) lead to terminal 1 (ILL+) and the negative (-) lead to terminal 4 (ILL-).

    2. Check that the light comes on.

      OK:
      Light illuminates.

      If the result is not as specified, replace doom light switch.