Home › STEERING › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column)

MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE UPPER STEERING COLUMN COVER


C160535
  1. Remove the 2 screws.

    HINT:
    Turn the steering wheel to the right and left as necessary to remove the 2 screws.



    C162097
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



4. REMOVE LOWER STEERING COLUMN COVER


C160536
  1. Detach the 2 claws to remove the lower steering column cover.



5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B166023
  1. Detach the 2 claws.

  1. Disconnect the hood lock control cable and remove the hood lock lever.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B226740
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



8. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


C154523
  1. Remove the bolt and air duct.



9. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU


C162089
  1. Disconnect the 2 ECU connectors.

  1. Remove the 2 screws and ECU.