LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH |
![]() |
Using a screwdriver, detach the 2 claws and remove the knob.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
Disconnect the switch connectors.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
Driver Side:
Disconnect the 2 connectors and detach the 4 clamps.
Passenger Side:
Disconnect the connector and detach the clamp.
![]() |
Remove the nut and front seat inner belt.
| 6. REMOVE INNER FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the screw.
Detach the 2 claws and clip, and then remove the cushion shield.
| 7. REMOVE FRONT SEATBACK COVER WITH PAD LH |
![]() |
w/ Seat Heater System or Climate Control Seat System:
Disconnect the seat heater connector and detach the wire harness clamp.
![]() |
Detach the hook.
![]() |
Remove the hog rings and seatback cover wires.
![]() |
Remove the nut and seatback cover bracket from the seat frame.
![]() |
Detach the 4 claws and remove the 2 headrest supports.
![]() |
Remove the hog rings and seatback cover with pad.
| 8. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
w/ Climate Control Seat System:
![]() |
Disconnect the connector and detach the 2 clamps.
![]() |
Remove the 4 springs.
Detach the 4 hooks and remove the seatback spring.
![]() |
w/o Climate Control Seat System:
Remove the 2 springs.
Detach the 6 hooks and remove the seatback spring.
![]() |
Disconnect the lumbar support adjuster connector.
Remove the 2 screws and lumbar support adjuster.