Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the sliding roof system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Using the Techstream, check if the LIN communication system is functioning normally.

      Result 
      Result
      Proceed to
      LIN communication system DTC is not output
      A
      LIN communication system DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).


    2. Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    GO TO STEP 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Operation Check (Click here)

    2. Initialization (Click here)

    3. Terminals of ECU (Click here)

    4. Data List / Active Test (Click here)


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END