Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > Sliding Roof ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.

WIRING DIAGRAM


B171240E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (IGNITION SWITCH SIGNAL)
  1. Use the Data List to check if the ignition switch signal is functioning properly (Click here).

    Sliding Roof 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Ignition (MPX)
    Ignition switch signal (MPX signal)/ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    Ignition (Direct Signal)
    Ignition switch signal/ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -

    OK:
    The Techstream displays as shown in the table according to the operation of each switch.



NG
Go to step 2
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)  

2.INSPECT FUSE (S/ROOF, ECU-IG No. 1)
  1. Remove the S/ROOF and ECU-IG No. 1 fuses from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S/ROOF fuse
    Always
    Below 1 Ω
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)
B130117E12
  1. Disconnect the W3 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage :
    Tester Connection
    Condition
    Specified Condition
    W3-9 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    W3-9 (IG) - Body ground
    Ignition switch off
    Below 1 V
    W3-10 (B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W3-8 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)