Home › ENGINE ยท 3UR-FBE › EMISSION CONTROL › AIR PUMP

AIR PUMP > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER LINER RH


    A160255
  1. Remove the 9 clips and fender liner.



2. DISCONNECT FRONT FENDER APRON SEAL RH


    A153461
  1. Using a clip remover, remove the 2 clips and fold back the fender apron seal.



3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE


    A158592E01
  1. Engine Room Side:

    1. Disconnect the 2 clamps.

    2. Disconnect the No. 2 hose.

    3. Using a clip remover, remove the clamp from the body panel.

  1. Front Fender RH Inside:

    1. Disconnect the clamp.

    2. Disconnect the No. 2 hose from the air pump.



4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE


    A158593E02
  1. Engine Room Side:

    1. Disconnect the clamp and No. 3 hose.

    2. Using a clip remover, remove the clamp from the body panel.

  1. Front Fender RH Inside:

    1. Disconnect the No. 3 hose from the air pump.

    2. Using a clip remover, remove the clamp from the body panel.



5. REMOVE AIR PUMP ASSEMBLY WITH BRACKET


    A158597
  1. Disconnect the 2 air pump connectors and detach the 3 wire harness claws.



    A158659
  1. Remove the 2 bolts, 2 nuts and air pump.



6. REMOVE AIR PUMP INLET


    A273866E01
  1. Remove the 2 bolts and air pump inlet.



7. DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE
  1. Disconnect the 2 hoses.



8. REMOVE AIR PUMP ASSEMBLY


    A153467
  1. Using a clip remover, detach the 2 clamps and remove the air pump from the bracket.

  1. Disconnect the 6 air pump insulators.