ENGINE OIL COOLER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
| 4. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 5. REMOVE FAN & GENERATOR V BELT |
Remove the fan and generator V belt (Click here)
| 6. REMOVE OIL FILTER ELEMENT |
Remove the oil filter element (Click here).
| 7. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the sender gauge connector.
![]() |
Remove the oil pressure sender gauge.
| 8. DISCONNECT COOLER COMPRESSOR ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and 2 stud bolts, and disconnect the cooler compressor.
| 9. REMOVE NO. 2 WATER BY-PASS PIPE |
![]() |
Remove the 3 bolts.
Remove the 4 hoses and water by-pass pipe.
| 10. REMOVE NO. 1 OIL COOLER BRACKET |
![]() |
Remove the 2 nuts and bracket.
Disconnect the ground wire from the cylinder block.
| 11. REMOVE OIL FILTER BRACKET |
![]() |
Remove the 2 bolts, 2 nuts and filter bracket.
![]() |
Remove the 2 O-rings.
| 12. REMOVE OIL COOLER ASSEMBLY |
![]() |
Remove the 5 nuts and oil cooler from the oil filter bracket.
![]() |
Remove the 2 O-rings.
| 13. REMOVE OIL COOLER SPACER |
![]() |
Remove the bolt and oil cooler spacer from the oil filter bracket.
![]() |
Remove the gasket.