POWER STEERING OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT POWER STEERING OIL PRESSURE SWITCH |
Check the oil pressure switch.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering pressure.
Start the engine.
Operate the steering wheel while idling, and read the value on the Techstream.
| Measurement Condition | Specified Condition |
| Power steering not operating | 0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi) |
| Power steering operating | Values change from above value |