FRONT CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 4. REMOVE INLET RADIATOR HOSE |
| 5. REMOVE FAN & GENERATOR V BELT |
![]() |
While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
Remove the V belt.
| 6. REMOVE FAN SHROUD |
![]() |
Loosen the 4 nuts holding the fluid coupling fan.
Remove the fan and generator V-belt.
Disconnect the reservoir hose from the upper radiator tank.
![]() |
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the fan bracket.
| 7. DISCONNECT FRONT STABILIZER BAR |
![]() |
Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes. Then disconnect the stabilizer bar.
| 8. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the sender gauge connector.
![]() |
Remove the oil pressure sender gauge.
| 9. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler) |
![]() |
Remove the 2 bolts, 2 nuts and oil filter bracket.
![]() |
Remove the 2 O-rings.
| 10. DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler) |
![]() |
Remove the 3 bolts and disconnect the 2 water by-pass hoses from the oil cooler.
| 11. REMOVE NO. 1 OIL COOLER BRACKET (w/ Oil Cooler) |
![]() |
Remove the 2 nuts and bracket.
Disconnect the ground wire from the cylinder block.
| 12. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler) |
![]() |
Remove the 2 bolts, 2 nuts and filter bracket.
![]() |
Remove the 2 O-rings.
| 13. REMOVE CRANKSHAFT PULLEY |
![]() |
Using SST, loosen the crankshaft pulley set bolt.
Partially install the pulley set bolt to the crankshaft until 2 or 3 threads are engaged.
![]() |
Using the pulley set bolt and SST, remove the crankshaft pulley.
| 14. REMOVE CRANKSHAFT TIMING GEAR KEY |
![]() |
Remove the crankshaft timing gear key from the crankshaft.
| 15. REMOVE FRONT CRANKSHAFT OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal.