Home › ENGINE ยท 1UR-FE › ENGINE CONTROL SYSTEM › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE TAILPIPE ASSEMBLY


    A215356
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe from the exhaust pipe support.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A215354
  1. Remove the 4 bolts.

  1. Disconnect the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the center exhaust pipe from the front exhaust pipe and front No. 3 exhaust pipe.

  1. Remove the 2 gaskets from the front exhaust pipes.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector and 2 clamps.

  1. Disconnect the air fuel ratio sensor connector.



    A215358
  1. Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.



4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A215441E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



5. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)


C158452
  1. Remove the 2 bolts and heat insulator from the heat insulator bracket.



6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 4WD)
  1. Disconnect the heated oxygen sensor connector.

  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the front No. 2 exhaust pipe from the exhaust pipe support.



    A215357
  1. Remove the 3 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.



7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
  1. for 2WD:
    Disconnect the air fuel ratio sensor connector.



    A215438E01
  1. Using SST, remove the sensor.

    SST
    09224-00010