ECM > INSTALLATION |
| 1. INSTALL GASKET |
Clean the ECM seal's surface with non-residue solvent.
Attach a new gasket to the ECM.
| 2. INSTALL ECM |
![]() |
Install the ECM with the 4 bolts.
![]() |
Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.
| 3. INSTALL CONNECTOR HOLDER BLOCK |
![]() |
Install the connector holder block with the 3 bolts.
| 4. ALCOHOL DENSITY LEARNING INITIALIZATION |
Clear DTCs.
| 5. ALCOHOL DENSITY LEARNING |
Connect the Techstream to the DLC3.
Start the engine and allow it to idle for approximately 10 minutes.
Turn the Techstream main switch ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Alcohol Density Learning
Check that "Compl" is displayed for "Alcohol Density Learning".
If "Compl" is not displayed, drive the vehicle for approximately 15 minutes, and then check "Alcohol Density Learning" again.
| 6. PERFORM INITIALIZATION |
Perform initialization .