ECM > INSTALLATION |
| 1. INSTALL GASKET |
Clean the ECM seal's surface with non-residue solvent.
Attach a new gasket to the ECM.
| 2. INSTALL ECM |
![]() |
Install the ECM with the 4 bolts.
![]() |
Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.
![]() |
Connect the wire harness clamp.
| 3. CONNECT CONNECTOR HOLDER BLOCK |
![]() |
Connect the connector holder block with the 3 bolts.
Install the connector holder block cover.
| 4. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Install the air cleaner with the 2 bolts.
Tighten the hose clamp.
Connect the ventilation hose and vacuum hose.
Connect the MAF meter connector and clamp.
| 5. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.