Home › BODY ELECTRICAL › AUDIO / VISUAL › VIDEO TERMINAL (for Separate Seat Type)

VIDEO TERMINAL (for Separate Seat Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    B227980
  1. Using a moulding remover, detach the 7 clips and remove the end panel.

  1. except Regular Cab:
    Detach the 2 wire harness clamps and disconnect the connector.



4. REMOVE VIDEO TERMINAL


    B164815
  1. Detach the clamp from the end panel.



    B168490
  1. Detach the 4 claws and remove the video terminal.