REAR DOOR LOCK (for CrewMax) > INSTALLATION |
| 1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH |
![]() |
Install the rear door inside locking cable.
![]() |
Attach the 3 claws.
| 2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH |
![]() |
Install the rear door lock remote control cable.
![]() |
Attach the claw.
| 3. INSTALL REAR DOOR LOCK ASSEMBLY LH |
Apply MP grease to the sliding and rotating parts of the rear door lock.
Install a new door lock wire harness packing to the door lock.
![]() |
Using a T30 ''TORX'' wrench, install the door lock with the 3 screws.
Connect the connector.
| 4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Insert the door glass into the door panel along the glass run as indicated by the arrows in the illustration.
Install the door glass to the window regulator with the 2 bolts.
| 5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH |
![]() |
Install the rear door rear lower window frame to the door panel with the 2 bolts.
| 6. INSTALL REAR DOOR GLASS RUN LH |
![]() |
Install the rear door glass run.
| 7. INSTALL REAR DOOR SERVICE HOLE COVER LH |
![]() |
Attach the 5 clamps to install the rear door service hole cover.
| 8. INSTALL REAR NO. 2 DOOR TRIM BRACKET |
![]() |
Install the bracket with the 2 screws.
| 9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Connect the 2 cables to the inside handle.
![]() |
Attach the inside handle's knob to the door trim board.
for 12 Speakers:
Connect the connector.
Attach the 10 clips to install the door trim board.
Install the inside handle and door trim board to the door trim panel with the screw.
Install the door trim board to the door panel with the screw.
Install the clip.
| 10. INSTALL REAR DOOR ARMREST COVER LH |
| 11. INSTALL REAR DOOR FRAME GARNISH LH |
![]() |
Attach the 5 clips to install the rear door frame garnish.
| 12. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH |
![]() |
Connect the connector.
Attach the 2 clips to install the rear door armrest upper base panel.
| 13. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Attach the 4 claws to install the bezel plug.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |