CAN COMMUNICATION SYSTEM > Power Steering ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Power Steering ECU Communication Stop Mode | Either condition is met:
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (POWER STEERING ECU BRANCH WIRE) |
![]() |
Disconnect the J119 power steering ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J119-1 (CANH) - J119-2 (CANL) | Ignition switch OFF | 54 to 69 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND) |
Reconnect the cable to the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J119-3 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J119-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||