Home › STEERING › POWER STEERING › POWER STEERING ECU (for 1UR-FE)

POWER STEERING ECU (for 1UR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING ECU ASSEMBLY


C181335
  1. Install the power steering ECU with the nut.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the power steering ECU connector.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B227982
  1. Connect the connector and attach the wire harness clamp.

  1. Attach the 12 clips to install the finish panel.



3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B163883
  1. for Automatic Air Conditioning System:
    Attach the 2 claws to install the sensor.



    B226740
  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 bolts.

  1. Install the hood lock control lever.



5. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



6. INSTALL COWL SIDE TRIM BOARD LH


B165704
  1. Attach the 2 clips to install the cowl side trim board.

  1. Install the clip.



7. INSTALL FRONT DOOR SCUFF PLATE LH


B165843
  1. Attach the 6 claws and 3 clips to install the front door scuff plate.