Home › ENGINE ยท 3UR-FBE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A196290E01
  1. Apply a light coat of spindle oil or gasoline to the 2 O-rings.

    NOTICE:
    1. Make sure that there are no scratches or foreign matter in or around the hole of the delivery pipe.
    2. When installing the fuel pressure pulsation damper, be careful not to damage the O-ring.



    A194640
  1. Install the 2 fuel pressure pulsation dampers to the fuel delivery pipes.



2. INSTALL FUEL PRESSURE PULSATION DAMPER COVER


    A194639
  1. Install the 2 fuel pressure pulsation damper covers with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL FUEL PRESSURE PULSATION DAMPER CAP


    A194638
  1. Install the 2 fuel pressure pulsation damper caps.



4. INSTALL NO. 3 ENGINE COVER


5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


6. CONNECT VENTILATION HOSE


    A198623
  1. Connect the ventilation hose.



7. INSTALL AIR CLEANER HOSE ASSEMBLY


    A187008
  1. Install the air cleaner hose with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the vacuum hose and ventilation hose.



8. INSTALL V-BANK COVER SUB-ASSEMBLY


    A165576E02
  1. Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.



9. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and Techstream main switch on.

    NOTICE:
    Do not start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.