Home › ENGINE · 3UR-FBE › FUEL › FUEL PRESSURE SWITCHING VALVE

FUEL PRESSURE SWITCHING VALVE > INSPECTION

for Preparation Click here



1. INSPECT FUEL PRESSURE SWITCHING VALVE


A194682E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground
    1 - 2
    20°C (68°F)
    5 to 10 Ω

    If the result is not as specified, replace the valve.



  1. Inspect the valve operation.



      A194680E01
    1. Check that air flows from port A to ports B and C.



    2. A194681E01
    3. Apply battery voltage across the terminals as shown in the illustration.

      NOTICE:
      1. Keep the valve as far away from the battery as possible.
      2. Always turn the voltage on and off on the battery side, not the valve side.

    4. Check that air flows from port A to port C.
      If the result is not as specified, replace the valve.