VEHICLE STABILITY CONTROL SYSTEM > TRAC OFF Indicator Light Remains ON |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK DTC (FOR SFI SYSTEM) |
for 1GR-FE:
Clear the DTC (SFI system) (Click here).
for 1UR-FE:
Clear the DTC (SFI system) (Click here).
for 3UR-FE:
Clear the DTC (SFI system) (Click here).
for 3UR-FBE:
Clear the DTC (SFI system) (Click here).
for 1GR-FE:
Check the DTC (SFI system) (Click here).
for 1UR-FE:
Check the DTC (SFI system) (Click here ).
for 3UR-FE:
Check the DTC (SFI system) (Click here).
for 3UR-FBE:
Check the DTC (SFI system) (Click here).
| Result | Proceed to |
| DTC (SFI system) is not output | A |
| DTC (SFI system) is output (for 1GR-FE) | B |
| DTC (SFI system) is output (for 1UR-FE) | C |
| DTC (SFI system) is output (for 3UR-FE) | D |
| DTC (SFI system) is output (for 3UR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (TRC(TRAC) OFF INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the TRAC OFF indicator light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| TRC(TRAC) OFF Indicator Light | TRAC OFF indicator light | ON / OFF | Observe combination meter |
Check that the TRAC OFF indicator light turns on and off in the combination meter when using the Techstream.
|
| ||||
| OK | |
| 4.INSPECT VSC OFF SWITCH |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 - 9 | Switch is pressed | Below 1 Ω |
| Switch is not pressed | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
![]() |
Disconnect the A17 ECU connector.
Disconnect the J22 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-4 (CSW) - J22-9 | Always | Below 1 Ω |
| A17-4 (CSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||