HEADLIGHT LEVELING SWITCH > INSPECTION |
| 1. INSPECT HEADLIGHT LEVELING SWITCH |
![]() |
Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (B) - 2 (T) | 0 | 10.4 to 11.2 V |
| 1 | 8.52 to 9.24 V | |
| 2 | 6.6 to 7.32 V | |
| 3 | 4.68 to 5.40 V | |
| 4 | 2.76 to 3.48 V | |
| 5 | 0.84 to 1.56 V |
Apply battery voltage to the connector and check the LED illumination condition.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 4 (ILL-) | LED illuminates |
| *1 | Component without harness connected (Headlight Leveling Switch) |