Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > USB Audio System Recognition/Play Error

for Preparation Click here


INSPECTION PROCEDURE

  1. When a large amount of data is in a USB device, it may take a while to begin playing.
  2. When using a USB device, files that are protected by copyright cannot be played.
  3. When files are not played in the sorted order, perform the following procedure before inspection.
    1. Add numbers in front of the file names.
    2. Put the files in a folder and copy the folder data to the USB device.
1.CHECK USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the stereo jack adapter.

  1. Check if playable files are present on the USB device or "iPod".

    HINT:
    Refer to System Description for playable files (Click here).

  1. Check if the USB device is a compatible format or "iPod" is a compatible version.

    HINT:
    Refer to System Description for compatible formats and versions (Click here).

    Result 
    Result
    Proceed to
    No playable files exist, or incompatible device format or version
    A
    Playable files exist, and compatible device format or version
    B



B
Go to step 2
A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT 

2.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
  1. Delete all files in the USB device or "iPod" and format/restore it.

  1. Save the data again and check if it can be played on the in-vehicle device.

    NOTICE:
    Formatting a USB device or restoring an "iPod" erases all music on the device.
    Make sure that backup music data is available before performing this operation.

    OK:
    Malfunction disappears.



NG
Go to step 3
OK

END 

3.REPLACE USB DEVICE OR "iPod"
  1. Turn the ignition switch off.

  1. Turn the ignition switch to ACC.

  1. Connect a normally functioning USB device or "iPod" to the stereo jack adapter.

    HINT:
    1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
    2. Refer to System Description for compatible formats and versions (Click here).


NEXT


4.CHECK USB DEVICE OR "iPod"
  1. Check if the USB device or "iPod" is recognized by the navigation receiver, or if information such as track, artist and album names are displayed on screen.

OK:
USB device or "iPod" is recognized or track information such as track, artist and album names are displayed.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE