Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU

for Preparation Click here


DESCRIPTION

The multi-media interface ECU sends sound signals to the navigation receiver assembly through this circuit. If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly or speakers.

WIRING DIAGRAM


E190585E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - MULTI-MEDIA INTERFACE ECU)


    E191663E01
  1. Disconnect the K8 navigation receiver assembly connector.

  1. Disconnect the J107 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K8-2 (CDR+) - J107-2 (URO+)
    Always
    Below 1 Ω
    K8-3 (CDR-) - J107-3 (URO-)
    Always
    Below 1 Ω
    K8-4 (CDL+) - J107-4 (ULO+)
    Always
    Below 1 Ω
    K8-5 (CDL-) - J107-5 (ULO-)
    Always
    Below 1 Ω
    K8-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    K8-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    K8-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    K8-5 (CDL-) - Body ground
    Always
    10 kΩ or higher
    J107-1 (USD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)