NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Stereo Component Tuner Assembly and Multi-media Interface ECU |

| 1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - MULTI-MEDIA INTERFACE ECU) |
![]() |
Disconnect the K27 stereo component tuner assembly connector.
Disconnect the J108 multi-media interface ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K27-2 (FRO+) - J108-8 (URI+) | Always | Below 1 Ω |
| K27-3 (FRO-) - J108-16 (URI-) | Always | Below 1 Ω |
| K27-4 (FLO+) - J108-7 (ULI+) | Always | Below 1 Ω |
| K27-5 (FLO-) - J108-15 (ULI-) | Always | Below 1 Ω |
| K27-2 (FRO+) - Body ground | Always | 10 kΩ or higher |
| K27-3 (FRO-) - Body ground | Always | 10 kΩ or higher |
| K27-4 (FLO+) - Body ground | Always | 10 kΩ or higher |
| K27-5 (FLO-) - Body ground | Always | 10 kΩ or higher |
| K27-1 (SLD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||