NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO JACK ADAPTER) |
![]() |
Disconnect the K21 navigation receiver assembly connector.
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K21-17 (ALI) - J100-6 (ALO) | Always | Below 1 Ω |
| K21-15 (ARI) - J100-5 (ARO) | Always | Below 1 Ω |
| K21-16 (ASGN) - J100-7 (ASGN) | Always | Below 1 Ω |
| K21-18 (AUXG) - J100-9 (AGND) | Always | Below 1 Ω |
| K21-19 (AUXI) - J100-8 (AUXO) | Always | Below 1 Ω |
| K21-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| K21-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| K21-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| K21-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||