EXHAUST MANIFOLD > REMOVAL |
| 1. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 2. REMOVE AIR CLEANER CAP AND HOSE |
![]() |
Remove the air cleaner cap and hose.
Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.
Loosen the clamp.
Detach the 4 hook clamps, and then remove the air cleaner cap and hose.
| 3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
Remove the air cleaner filter element.
![]() |
Remove the 2 bolts and air cleaner case.
| 4. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 5. REMOVE FRONT FENDER APRON SEAL REAR LH |
Remove the 5 clips and fender apron seal.
| 6. REMOVE FRONT FENDER APRON SEAL REAR RH |
Remove the 5 clips and fender apron seal.
| 7. REMOVE MANIFOLD STAY |
![]() |
Remove the 3 bolts and manifold stay.
| 8. REMOVE AIR TUBE |
![]() |
Remove the 2 bolts, 2 nuts and air tube.
Remove the 2 gaskets from the air tube.
| 9. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and heat insulator.
| 10. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH |
![]() |
Remove the 6 nuts, manifold and gasket.
| 11. REMOVE NO. 2 MANIFOLD STAY |
Disconnect the wire harness connector.
![]() |
Remove the 3 bolts and No. 2 manifold stay.
| 12. REMOVE NO. 2 AIR TUBE |
![]() |
Remove the 2 bolts, 2 nuts and No. 2 air tube.
Remove the 2 gaskets from the No. 2 air tube.
| 13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and heat insulator.
| 14. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH |
![]() |
Remove the 6 nuts, manifold and gasket.