Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > INITIALIZATION

for Preparation Click here



Fuel Density Learning Value Reset
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / Fuel Density Learning Value Reset.

  5. Check that the following conditions are met.

    1. Ignition switch: ON

    2. Engine: stopped

    3. Battery voltage: 9 V or higher

  6. Press "Next".

    HINT:
    When "Next" is pressed, initialization is performed automatically.

  7. Press "Exit".