DTC U0155 Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0155 |
|
|
| Related DTCs | U0155: Verify communication |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 2.9 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Battery Voltage | 10.5 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| Communication signal | Lost communication with combination meter |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC OUTPUT (DTC U0155) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| No output | A |
| U0155 | B |
|
| ||||
| A | ||
| ||