Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E231119E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the J122 navigation receiver assembly connector.

  1. Disconnect the J100 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J122-1 - J100-1
    Always
    Below 1 Ω
    J122-2 - J100-2
    Always
    Below 1 Ω
    J122-3 - J100-3
    Always
    Below 1 Ω
    J122-4 - J100-4
    Always
    Below 1 Ω
    J122-1 - Body ground
    Always
    10 kΩ or higher
    J122-2 - Body ground
    Always
    10 kΩ or higher
    J122-3 - Body ground
    Always
    10 kΩ or higher
    J122-4 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)