- NOTICE:
- Perform Reset Memory (AT initialization) for 2WD when replacing the automatic transmission assembly, engine assembly or ECM (Click here).
- Perform Reset Memory (AT initialization) for 4WD when replacing the automatic transmission assembly, engine assembly or ECM (Click here).
- Perform Registration (VIN registration) when replacing the ECM (Click here).
- Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components .
- HINT:
- The engine learned value cannot be reset by disconnecting the battery negative (-) terminal or removing the EFI NO. 1 and ETCS fuses.
- CAUTION:
- Observe the following items for safety reasons:
- Read the Techstream instruction books before using the Techstream.
- Make sure that the Techstream cable is not caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
- When driving the vehicle for testing purposes using the Techstream, two persons are required. One is for driving the vehicle, and the other operates the Techstream.