DTC P0101 Mass Air Flow Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0101 | Conditions (a), (b), (c), (d) and (e) continue for more than 10 seconds (2 trip detection logic): (a) Engine running (b) Engine coolant temperature 70°C (158°F) or higher (c) Throttle Position (TP) sensor voltage 0.2 V or more and below 3.6 V (d) Average engine load value ratio less than 0.85, or more than 1.15 (varies with estimated engine load) Average engine load value ratio = Average engine load based on MAF meter output / Average engine load estimated from driving conditions (e) Average air-fuel ratio less than -15%, or more than 15% |
|
| Related DTCs | P0101: Mass air flow meter rationality |
| Required Sensors/Components (Main) | Mass air flow meter |
| Required Sensors/Components (Related) | Crankshaft Position (CKP) sensor, Engine Coolant Temperature (ECT) sensor and Throttle Position (TP) sensor |
| Frequency of Operation | Continuous |
| Duration | 10 times |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Throttle position (TP sensor voltage) | 0.2 to 3.6 V |
| Time after engine start | 5 seconds or more |
| Battery voltage | 10.5 V or more |
| Engine coolant temperature | 70°C (158°F) or more |
| Estimated load | 30 to 100% |
| Mass air flow meter circuit failure (P0102, P0103) | Not detected |
| Intake air temperature circuit failure (P0112, P0113) | Not detected |
| Engine coolant temperature circuit failure (P0115, P0117, P0118) | Not detected |
| Crankshaft position sensor circuit failure (P0335, P0337, P0338) | Not detected |
| Throttle position sensor circuit failure (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |
| EVAP system pressure sensor circuit failure (P0452, P0453) | Not detected |
| Fuel level sensor circuit failure (P0461, P0462, P0463) | Not detected |
| Leak detection pump failure (P2401, P2402) | Not detected |
| EVAP vent valve failure (P2419, P2420) | Not detected |
| Both of following conditions 1 and 2 met | - |
| 1. Averaged engine load value ratio | Less than 0.85, or more than 1.15 (varies with estimated engine load) |
| 2. Averaged air-fuel ratio | Less than -15%, or more than 15% |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P0101 is output | A |
| P0101 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leakage .
|
| ||||
| OK | |
| 3.CHECK PCV HOSE CONNECTIONS |
Check the PCV hose connections.
|
| ||||
| OK | ||
| ||