THROTTLE BODY > INSTALLATION |
| 1. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY |
Install a new gasket and the throttle body with motor with the 4 bolts.
Connect the throttle position sensor and throttle control motor connector.
Connect the No. 4 water by-pass hose to the throttle body with motor assembly, and slide the clamp to secure the hose.
Connect the No. 5 water by-pass hose to the throttle body with motor assembly, and slide the clamp to secure the hose.
| 2. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose with the 2 clamps.
| *1 | Paint Mark |
| *a | Protrusion |
| *b | Groove |
| *c | Top |
| *d | RH |
| *e | Front |
Connect the vacuum hose and ventilation hose.
Attach the wire harness clamp.
| 3. ADD ENGINE COOLANT |
Add engine coolant.
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Install the radiator cap.*1
Start the engine and stop it immediately.*2
Allow approximately 10 seconds to pass. Then remove the radiator cap and check the coolant level. If the coolant level has decreased, add coolant.*3
Repeat steps *1, *2 and *3 until the coolant level does not decrease.
Install the radiator cap.*4
Set the air conditioning as follows.*5
| Item | Condition |
| Fan speed | Any setting except off |
| Temperature | Toward WARM |
| Air conditioning switch | Off |
Start the engine, warm it up until the thermostat opens, and then continue to run the engine for several minutes to circulate the coolant.*6
Stop the engine, wait until the engine coolant cools down to ambient temperature. Then remove the radiator cap and check the coolant level.*7
If the coolant level has decreased, add coolant and warm up the engine until the thermostat opens.*8
If the coolant level has not decreased, check that the coolant level in the radiator reservoir is at the FULL line.
If the coolant level is below the FULL line, repeat steps *4 through *8.
If the coolant level is above the FULL line, drain coolant until the coolant level reaches the FULL line.
| 4. INSPECT FOR ENGINE COOLANT LEAK |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 5. PERFORM INITIALIZATION |
Turn the ignition switch to ON without operating the accelerator pedal.
Connect the Techstream tester to the DLC3 and clear the DTCs (Click here).
Perform the "Inspection After Repairs" (Click here).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
| Condition | Engine Idle Speed |
| A/C switched off | 650 to 750 rpm |
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Pos. Sensor Output. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.