AIR FUEL RATIO SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR FUEL RATIO SENSOR |
Disconnect the 2 air fuel ratio sensor connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (HA1A) - 2 (+B) (for Bank 1) | 20°C (68°F) | 1.6 to 3.2 Ω |
| 1 (HA2A) - 2 (+B) (for Bank 2) |
| *A | for Bank 1 |
| *B | for Bank 2 |
| *a | Component without harness connected (Air Fuel Ratio Sensor) |
Reconnect the 2 air fuel ratio sensor connectors.