STEERING ANGLE SENSOR > INSTALLATION |
| 1. INSTALL STEERING ANGLE SENSOR |
![]() |
Attach the 3 claws and install the spiral cable sub-assembly with steering sensor.
Connect the connectors to the spiral cable sub-assembly with steering sensor.
| 2. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Attach the 3 claws and install the spiral cable sub-assembly with steering sensor.
Connect the connectors to the spiral cable sub-assembly with steering sensor.
| 3. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 4. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 5. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is OFF.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks.
| 6. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
| *a | Matchmark |
Install the steering wheel set nut.
| 7. INSTALL STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
| 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the guide and claw to install the lower No. 3 steering wheel cover.
| 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
w/ Cruise Control:
Attach the guide and claw to install the lower No. 2 steering wheel cover.
![]() |
w/o Cruise Control:
Attach the guide and claw to install the lower No. 2 steering wheel cover.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).