Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here


HINT:
If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.


Vehicle Condition
Auto Cancel Condition
Fail-safe Deactivation Condition
Cruise control indicator light blinks
  1. Open or short in stop light switch circuit
  2. Problem with vehicle speed signal
Cruise control system is turned off and back on again using the cruise control min switch.
  1. Problem with stop light switch input circuit
  2. Problem with cruise control main switch cancel circuit
Ignition switch is turned off and back to ON again.
Cruise control indicator remains illuminated (Cruise control system control of vehicle speed is canceled)
  1. Vehicle speed is lower than low speed limit (approximately 40 km/h (25 mph)) while driving with cruise control system controlling vehicle speed
  2. VSC system operates while driving with cruise control system controlling vehicle speed
Cruise control main switch is pushed to +/RES
Vehicle speed is lower than stored speed by approximately 16 km/h (10 mph) or more
Cruise control main switch is pushed to +/SET
Cruise control indicator goes out
Problem with throttle position sensor or motor
Cruise control system is turned off and back on again using the cruise control min switch.